Rider-Ericsson
Hot Air Water Pumping Engine
3 in. Bore Casting Kit with Drawings

Shown here is a  finished model based off a water pumping engine produced in the late 1800's and early 1900's by the Rider-Ericsson Co.

Originally the engine was made in differing sizes ranging from a 4 in. bore to a 10 in. bore.

Other sizes we offer are located here.

• 3 in. Dia cylinder Bore
• 25 in. High (To top of flywheel)
• 20 3/8 in. Long
• 9 1/4 in. Deep
• 13 in. Dia. Flywheel
• 12 Aluminum Castings
  • Legs
  • Base
  • Firebox and door
  • Cylinder
  • Yoke
  • Cylinder Knee
  • Flywheel
  • Beam Bracket
  • Beam
  • Pump
• 1 Iron Casting (Piston)
• 2 Pieces of Steel Tubing
• Stack elbow and pipe
• Shipping Weight: Approximately 50 lbs.